Three-phase pmw inverter
The three-phase inverter uses insulated gate bipolar transistor (IGBT) switches which have advantages of high input impedance as the gate is insulated, has a rapid response ability, good thermal stability, simple driving circuit, good ability to withstand high voltage, snubber-less operation and controllability of switching behavior providing reliable short-circuit protection. [pdf]
Solar power generation uses a slightly larger inverter
Off-grid solar systems are usually larger in inverter size due to independent operation and reliance on battery storage, matching Battery Bank capacity with peak load and integrating complex functions (e.g., battery management); whereas on-grid systems are smaller in inverter capacity due to interconnection with the grid, matching solar panel power and ensuring grid synchronization, with simplified functional design and a relatively low cost. [pdf]
New Energy Ultra-High Voltage Inverter
The HC1000W series is a water-cooled high-voltage inverter designed for ultra-high power loads, which can achieve a strong output of up to 60MW, and at the same time integrates long-life components with redundant fault-tolerant technology, adopts thin film capacitors, low voltage ride-through and other designs to comprehensively improve reliability, and can provide reliable high-voltage variable frequency drive solutions for equipment in the range of 5-60MW to ensure stable operation of loads for more than 30 years. [pdf]
New Energy Battery Cabinet Base Station Power Generation Method
Base station energy cabinet: a highly integrated and intelligent hybrid power system that combines multi-input power modules (photovoltaic, wind energy, rectifier modules), monitoring units, power distribution units, lithium batteries, smart switches, FSU and ODF wiring, etc., to effectively solve Various functional requirements such as power supply, backup power supply, and optical network access of base station communication equipment. [pdf]
Battery current measurement method for communication base station
Aiming at the voltage and current measurement for battery banks in mobile communication base station, according to voltage characteristics of wide common-mode range, three methods including sampling with resistors, converting with analog optical coupler and differential subtractor based on amplifier are presented.For bi-directional current characteristic, both single and double amplifier methods are discussed respectively.Also, all the methods mentioned above are analyzed. [pdf]
Contact MOBICENTRIC SOLAR
We are committed to excellence in solar power plants and energy storage solutions.
With complete control over our manufacturing process, we ensure the highest quality standards in every solar system and energy storage cabinet we deliver.